Cricket advice

Getting a good bat isn’t just about buying a nice model, it’s also about how you look after it.


Use raw linseed oil or special bat oil. Apply a small amount of oil (about size of a 50p/inch in diameter) to the face of the bat and then work it in to the rest of the blade, edges, toe and back. But do not oil the splice area as this may soften the glue.

Keep the bat horizontal on its back for 24 hours. This will allow the oil to soak in. When it is dry remove any oil that hasn’t soaked in – use fine sandpaper or scrape lightly with a sharp blade.

Repeat the process, but do not oil the back again. The bat is then ready for knocking-in and soon it'll be ready for its first game of cricket!

Do not over-oil. More bats are spoilt by over-oiling than by under-oiling. Over-oiling adds weight to the bat, deadens it and can even cause wood rot. Over-oiled bats take longer to be repaired, as they have to be dried out first.

Non-oil, coated or uncovered bats should not be oiled.

Knocking in

It’s important to look after your equipment in sport, and knocking your cricket bat in is key. This is best done with a purpose-made bat mallet – either ball-on-handle or smooth wooden mallet.

The aim of knocking-in is to continue a process which began at the bat factory when the blade was pressed between heavy steel rollers; namely to compress the soft willow so that it better stands up to the impact of the smaller, harder ball.

There are no rules to how long you should knock-in your bat. Like walnut trees ”the more you beat’em the better they bees”. However, make sure you give the edges including the toe edge a good going over.

Then play the bat in gently in the nets. Bat defensively, concentrate on getting the ball in the middle of the bat, do not ‘reach’ for the ball outside the off stump and don’t swing hard across the line.


All about cricket

If you’re just getting into cricket, this website has loads of tips for watching and playing that great game!

Choosing a bat

There is only one sensible way of choosing a bat; pick it up. Mail order catalogues are no good, as every individual bat is unique. Dead weight is largely irrelevant (though we would recommend that adult players should avoid over-light bats, weighing say less than 21b. 4oz.). Pick up weight is everything.

The ideal bat should weigh a ton and pick up like a feather. An exaggeration, but illustrative of the point. A heavy bat gives more power or weight behind the shot. It is also less susceptible to splitting. But too heavy and it is unwieldy.

It is essential that youngsters should not use bats which are too big or too heavy as it interferes with their shot thus retarding their development and inhibiting their enjoyment of batting. Nevertheless, good bats are not cheap and we are sympathetic to parents who want to choose a bat that will “do” for a couple of seasons. It’s all a question of good sense – and good advice. And many a player has made it to the Ashes starting with a humble bat.

What kind of bat?

A light bat is wieldier, which means that the hands holding the bat are able to respond more quickly to the message from the brain.

It hardly needs saying, but always choose English willow made by a reputable maker and sold to you by a knowledgeable cricket retailer who can offer you a good range to choose from. Also, willow bats look best in cricket pictures!

Covered bats: Bats, which are covered or coated, tend to be harder wearing. With a few exceptions they are cheaper as they are usually made of a lower grade willow. They can still play beautifully and are ideal for club and school bats or for the person who is maybe, a bowler who may only bat occasionally. They also do need oiling, though knocking-in is still recommended.


Contact us below